IC PIC16F57 8-bit Microcontroller Basic Stamp 2 Interpreter Chip 28-pin DIP

BASIC Stamp 2 Interpreter Chip (DIP)

Recommended for high volume applications or those with limited PCB real estate, the BASIC Stamp 2 (DIP) interpreter chip can be used on your own PCB as an OEM solution. All of the features that you have grown to appreciate in the corresponding BASIC Stamp 2 module are available through using an OEM design. The three main components needed to build your own BASIC Stamp are the PBASIC Interpreter Chip as shown on this page, EEPROM, and resonator.

This interpreter chip (PBASIC2/P) is the replacement for the former interpreter chip (PBASIC2C/P). No firmware changes or electrical changes are required in designs using this part as opposed to the previous part; they are fully compatible with each other.

Features:

• Supports PBASIC 1.0, 2.0 & 2.5
• Small footprint on a PCB ideal for OEM designs
• Easily replaceable if socketed into PCB
• Package Type: 28-pin DIP
• Interpreter chip is preprogrammed with the BASIC Stamp 2 Interpreter firmware

Specifications:

• Processor Speed: 20 MHz; approx. 4,000 PBASIC instructions/sec
• Power Requirements: 2.5 to 5.5 VDC
• Current requirements: 3 mA Run, 50 µA Sleep
• Communication: Serial
• I/O pins: 16
• Communication: N/A
• Dimensions: 1.430 x 0.600 x 0.150 in (36.32 x 15.24 x 3.81 mm)
• Operating Temperature: +32 to +158 °F (0 to +70 °C)

Resources & Downloads

• BASIC Stamp 2 App Notes
• BASIC Stamp 2 Schematic
• PBASIC Tokenizer
• PBASIC Editor for Linux Part 1
• PBASIC Editor for Linux Part 2
• BASIC Stamp Linux Solution
• BASIC Stamp Manual
• BASIC Stamp Editor Software for Windows
• BASIC Stamp Forum (Parallax Forums)

Report a problem
Suggest a product